Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Instrukcja Użytkownika Pobierz pdf (Strona 13)

SW 838023

GB Shuttle Manual 100316

Display and keyboard

The keyboard

From the Shuttle

keyboard the keys marked A - F (➀) gives access to 21 menus divided in

6 basic settings and 15 special settings.

There is direct access to the menus for basic settings by pressing one the keys A to F.

See appendix E for instructions for access to the special settings.

When a menu has been selected, settings are made with the UP and DOWN keys and

the selection is conﬁrmed with the ENTER key (

➃) whereafter Shuttle

reverts to normal

read-out. To leave any menu without changing the settings, press the UP and DOWN keys

simultaneously (ESCape, ➂).

➀ ➁

➂

➃

Basic settings

A (LEARNING)

Start and activation/deactivation of the

learning function.

B (UNIT)

Selection of measuring unit.

C (ZERO ADJUST)

Setting of sensor distance and zero

point.

D (mA OUTPUT)

Setting of the mA output.

E (RELAY 1)

Setting of the functions for relay

output # 1.

F (RELAY 2)

Setting of the functions for relay

output # 2.

(see pages 14 - 29)

Special settings

Shift + A (bA - bar graph readout)

Shift + B (rA - Active measuring range)

Shift + C (rE - response time for level

changes)

Shift + D (AP - Application setup)

Shift + E (S. Err - System error indication)

Shift + F (LE - Level readout calibration)

Esc + A (nAP - Setting of reference level)

Esc + B (Qu - Indication of signal quality)

Esc + C (Sh - Indication of signal ampliﬁ-

cation)

Esc + D (dE - Period without echo)

Esc + E (Choose sensor)

Esc + F (FA - Factory settings)

AxsC + A (S. Ln - HW/SW/Serial numbers)

AxsC + B (S.St - Find zero level at next

power-up)

AxsC + C (12nA - Constant mA signal out)

AxsC + D (nS - Investigative measurements

interval)

AxsC + E (S. Al - System alarm delay)

(see Appendix E)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag

Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji