Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Instrukcja Użytkownika Pobierz pdf (Strona 64)

GB Shuttle Manual 100316

SW 838023

Appendix

Averaging the level measurement

Enter the access code (see page 58) and press 'F':

When measuring on very turbulent liquid surfaces, it may be

needed to average the level changes in order to gain a more

steady level readout and level signal.

This menu is used to set the time from a level change is

measured and until the reading will be 99 % of the level

change.

See also page 49, 'Response time'.

Use the arrow keys to select a new value:

Conﬁrm the new setting:

Note: The variation on the mA output will change ac-

cordigly.

The actual setting is shown immediately:

(Value in seconds.)

Shuttle

is ready for a new selection of a password protect-

ed menu after pressing 'Enter'.

(Re-entering the access code is not necessary if a menu

selection is made within 5 minutes.)

Press 'Escape' if no further password protected menu

selections are needed …

... or conﬁrm with 'Enter' that the changes should be saved,

whereupon Shuttle

revert to normal read-out, and the next

password protected menu can be selected.

(Press 'Escape' if the changes should not be saved.)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70

Brak uwag

Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Instrukcja Użytkownika Strona 64